Try the command.

dd if=<original_file>.bit of=<new_file>.bit count=<the_rigth_size> count=1

and then try to configure the fpga <new_file>.bit


On 27/09/19 16:12, Aaron Montilla via USRP-users wrote:
> Hi,
> I am trying to set the connection between my PC and my USRP X310.
> I ran the command uhd_find_devices, and successfully it found the
> USRP. Then I use the uhd_usrp_probe command and I had the next error:
> aaron@leonard:~$ uhd_usrp_probe
> [INFO] [UHD] linux; GNU C++ version 7.4.0; Boost_106501;
> UHD_3.15.0.git-71-g18bc320d
> [INFO] [X300] X300 initialization sequence...
> [INFO] [X300] Maximum frame size: 1472 bytes.
> [INFO] [X300] Radio 1x clock: 200 MHz
> [INFO] [GPS] Found an internal GPSDO: LC_XO, Firmware Rev 0.929a
> [INFO] [0/DmaFIFO_0] Initializing block control (NOC ID:
> 0xF1F0D00000000000)
> [ERROR] [0/DmaFIFO_0] Major compat number mismatch for noc_shell:
> Expecting 6, got 5.
> Error: RuntimeError: FPGA component `noc_shell' is revision 5 and UHD
> supports revision 6. Please either upgrade the FPGA image
> (recommended) or downgrade UHD.
>
> I thought that upgrade the USRP was the best option, but when I try, I
> have another error saying that the size of the image is too large (
> only for 1 byte). I also read that I had to use the .bin file but I
> didn't have any.
> So, could you please tell me what I could do?
>
> Thank you very much in advance.
> Kind regards,
> Aaron
>
> _______________________________________________
> USRP-users mailing list
> USRP-users@lists.ettus.com
> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com


_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com

Reply via email to