Hi all, I have a two X310 with CBX-120 daughter board running on UHD version 3.13.0 on Ubuntu 16.04. I am using it to tx/rx LTE 5MHz BW and 10 MHz BW signals at 2.85MHz using directional LP0965 antennas. However after few minutes the USRP looses uplink RF connection.
Do I need to calibrate them? I did send the following commands without any RF connectors to calibrate. But I have the same issue. The master clock rate for LTE is 184.32e6 Hz. Do I need to send this as well. Any suggestions will be helpful. 1. sudo uhd_cal_rx_iq_balance --verbose --args="addr=192.168.40.2" --freq_start 2.4e9 --freq_stop 2.9e9 --freq_step 1e6 2. sudo uhd_cal_tx_iq_balance --verbose --args="addr=192.168.40.2" --freq_start 2.4e9 --freq_stop 2.9e9 --freq_step 1e6 3. sudo uhd_cal_tx_dc_offset --verbose --args="addr=192.168.40.2" --freq_start 2.4e9 --freq_stop 2.9e9 --freq_step 1e6 Regards Jaya ________________________________ NOTE: The information in this email and any attachments may be confidential and/or legally privileged. This message may be read, copied and used only by the intended recipient. If you are not the intended recipient, please destroy this message, delete any copies held on your system and notify the sender immediately. Toshiba Research Europe Limited, registered in England and Wales (2519556). Registered Office 208 Cambridge Science Park, Milton Road, Cambridge CB4 0GZ, England. Web: www.toshiba.eu/research/trl --------------------------------------------------------------------------------------- This email has been scanned for email related threats and delivered safely by Mimecast. For more information please visit http://www.mimecast.com ---------------------------------------------------------------------------------------
_______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
