Hi, Same happened to me once before. You need to follow this: https://kb.ettus.com/X300/X310_Device_Recovery
Good luck. Regards, Xavier On Fri, 15 Mar 2019 at 12:57, Ilay Nissim via USRP-users < usrp-users@lists.ettus.com> wrote: > Hi > > I am using x310 and after upgrading 13.01 to 13.3.1 > > I have an urgent issue > > My FPGA burn was stoppend in the beginning and now it seems there is a > brick > > No eth connection on either port > > Is there a golden image for the FPGA? > > And advice? > > Regards > > > > Regards, > Ilay Nissim > RT Embedded Team Leader > > Netline Communications Technologies Ltd > Tel: + (972) 36068171 <+972%203-606-8161> > Fax: + (972) 36068101 <+972%203-606-8101> > http://www.netlinetech.com/ > Azrieli Circular Tower , Menachem Begin 132, Tel-Aviv 67021, ISRAEL > > > > This email and the associated attachments may contain information that is > proprietary, privileged, confidential or otherwise protected from > disclosure. If you are not the intended recipient or otherwise have > received this message in error, you are not authorized to read, print, > retain, copy or disseminate this message or any part of it. If you are not > the intended recipient or otherwise have received this message in error, > please notify me immediately, destroy any paper copies and delete all > electronic files of the message. > _______________________________________________ > USRP-users mailing list > USRP-users@lists.ettus.com > http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com >
_______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
