Hi Marcus,

Yes, thanks for that clarification. I'd been thinking about automatic IQ
correction, which the AD9361/9364/9371 support. The file based IQ
correction will only be applied if the calibration utilities have already
been run on that daughterboard and system before.
http://files.ettus.com/manual/page_calibration.html

Regards,
Derek

On Tue, May 22, 2018 at 4:44 PM, Marcus D. Leech via USRP-users <
usrp-users@lists.ettus.com> wrote:

> On 05/22/2018 11:25 AM, Derek Kozel via USRP-users wrote:
>
> Hello Kunal,
>
> What daughterboard do you have? I do not believe that there is an IQ
> balance function on the N210. Those functions apply to the E31x, B2xx, and
> possibly N310 USRPs. There should be a DC notch filter which is selected on
> and off, but I would have to check to see if that applies to the N210.
>
> What difference in the spectrum are you expecting? What signals are you
> observing while doing these tests?
>
> Regards,
> Derek
>
> The N210 does indeed have DC offset and I/Q balance correction.  The I/Q
> balance correction is based on a calibration file (which is what the cal_*
>   utilities are for).
>
> But the DC-offset correction is board agnostic.
>
>
>
> On Tue, May 22, 2018 at 4:06 PM, kunal sankhe via USRP-users <
> usrp-users@lists.ettus.com> wrote:
>
>> Hi,
>>
>> I want to disable automatic calibration of DC offset and IQ imbalance in
>> USRP Source block.
>>
>> I am aware that I need to pass bool value 'false' as the argument to
>> *set_auto_dc_offset* and *set_auto_iq_balance*. The USRP Source block
>> itself provide this facility in the tab *FE Corrections*. However, it
>> does not seem to work. By providing 0 (boolean false) value in Enable DC
>> Offset Correction and Enable IQ Imbalance Correction do not disable the
>> automation DC offset and IQ Imbalance correction. I tested this with USRP
>> N210 by simply using USRP Source block centered at frequency 915MHz
>> connected with WX GUI FFT Sink. The spectrum plot does not show any changes
>> in both cases.
>>
>> If I want to force these changes in the UHD code (usrp_source_impl.cc and
>> usrp_source_impl.h), what changes do I need to make?
>>
>>
>> Thanks,
>> Kunal
>>
>>
>>
>>
>>
>> _______________________________________________
>> USRP-users mailing list
>> USRP-users@lists.ettus.com
>> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
>>
>>
>
>
> _______________________________________________
> USRP-users mailing 
> listUSRP-users@lists.ettus.comhttp://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
>
>
>
> _______________________________________________
> USRP-users mailing list
> USRP-users@lists.ettus.com
> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
>
>
_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com

Reply via email to