Correct, the master clock rate must be one of those three values. Others will have to weigh in on the specifics of set/get rx/tx rate.
On Fri, Mar 2, 2018 at 8:43 AM, Андрей 1 <andrew4...@rambler.ru> wrote: > When I set the 200 MHz function to set_rx_rate and then I request > get_rx_rate, then I get 100 MHz. > What values can I set for master clock rate? Only those three values? > > > 02.03.2018, 16:30, Daniel Jepson <daniel.jep...@ettus.com> > Hi, > > The X300/X310 supports three Sampling Rates: 120MHz, 184.32MHz, and > 200MHz. Your rate was most likely coerced to the most common rate of 200M. > The FPGA then performs decimation and interpolation such that the host > doesn't have to stream all that bandwidth (nor can it in most cases). The > streaming rate called out in your screen shots is 10.0Msps. > > Does that answer your question? > > -Daniel > > On Fri, Mar 2, 2018 at 7:57 AM, Андрей 1 via USRP-users < > usrp-users@lists.ettus.com> wrote: > > Hello > > When I open device with uhd_usrp_make in the terminal I see a message > "invalid sample rate 100 MHz actual rate is 200 MHz".The same message I see > when running application from uhd samples folder. > If I set sample rate 200 MHz and then read them from device I got 100 MHz. > > What does this mean and what is the maximum clock of the X300 in single > and multichannel mode? > > See png for detail. > > Thank you > > _______________________________________________ > USRP-users mailing list > USRP-users@lists.ettus.com <usrp-users@lists.ettus.com> > http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com > > > > > -- > > Daniel Jepson > > Digital Hardware Engineer > > National Instruments > > > > O: +1.512.683.6163 <(512)%20683-6163> > > daniel.jep...@ni.com > > -- Daniel Jepson Digital Hardware Engineer National Instruments O: +1.512.683.6163 daniel.jep...@ni.com
_______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
