Dear All, We would like to sense (i.e. sample) 100 MHz of 2.4GHz spectrum. My idea is to connect 2 USRPs (USRPN200 and USRP2) via a MIMO cable (available at ettus.com). Then, we configure each USRP separately to monitor 50MHz of bandwidth (8bit per sample).
My question: 1- is it possible to configure each USRP separately to monitor different spectrum segment? Example, USRPN200 senses 2400MHz to 2450MHz and USRP2 sense 2450MHz up to 2500MHz. If this is possible, is it possible to get the samples over one GigaBit Ethernet cable (i.e. connected to one USRP device)? Or we may need to take a cable out of each device and connect them to a switch, which feeds the host ? 2- is it possible to connect USRPN200 with USRP2 via a MIMO cable? Or we need to use two USRP devices of the same type? like two of USRPN200 or two of USRP2. Thanks Wahhab Albazrqaoe
_______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
