On 09/03/2017 08:46 AM, David via USRP-users wrote:
Hey all,
Thanks for the replies, didn't realise it would work on USB2... so I...
- plugged into USB2 port
- no boot up problems with the udev rule enabled
- get similar device read errors, until the device is unplugged &
plugged back in
- then uhd_usrp_probe works, no corruption of the fs :-)
- takes much longer to load fw!
- can't run uhd_fft however (...LIBUSB_ERROR_NO_DEVICE...)
So using USB2 port seems OK, but need to unplug, plug in the device
after each reboot, can do a
uhd_usrp_probe with no issues, and reboot OK, but uhd_fft fails (is
that expected?).
Why the difference between USB2 and USB3, thought the power (500mA)
was the same?
I've been wondering about power, esp. since reading the odroid forums,
I think, as you say Nate, a powered hub, or Y adaptor (I didn't know
about that) is the next step...
Marcus, is there a location for the Arch image please? I saw a
previous post from you about using b2x0's with XU4... :-)
Many Thanks,
Dave
https://archlinuxarm.org/platforms/armv7/samsung/odroid-xu4
_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
