Yes, You are right I am using X310. Thankyou for your quick response. Regards Nauman
From: Derek Kozel [mailto:derek.ko...@ettus.com] Sent: 31 July 2017 16:10 To: Iqbal N Mr (Elec Electronic Eng) <nauman.iq...@surrey.ac.uk> Cc: usrp-users@lists.ettus.com Subject: Re: [USRP-users] Configuration of E310 USRP Hello Nauman, I assume that you are using the X310 rather than the E310. It is not possible by default to use PCIe for configuration and control and then to use the SFP+ connections with Aurora for the sample streaming. The hardware could technically support such a configuration, but it would require extensive FPGA and host code development. I do not have a lot of familiarity with LabVIEW FPGA based workflows, but I would suggest looking into that as it is not impossible that that software stack could be made to support this. The base UHD and regular LabVIEW NI-USRP drivers do not support that set of configurations. Regards, Derek On Mon, Jul 31, 2017 at 2:22 PM, Nauman Iqbal via USRP-users <usrp-users@lists.ettus.com<mailto:usrp-users@lists.ettus.com>> wrote: Hi, I am looking at the UHD’s initialization of radio parameters. Is there a possibility if we can use the PCIe interface and Labview comms to configure the radios and at same time configure the streamers to be using 10gig Ethernet to send/receive baseband streams? So the configuration is done totally independently via PCIe and a labiew GUI, plus we want to use Aurora instead of the 10G Ethernet for the streamers. Regards Nauman _______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com<mailto:USRP-users@lists.ettus.com> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
_______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
