Hello Nauman, I assume that you are using the X310 rather than the E310.
It is not possible by default to use PCIe for configuration and control and then to use the SFP+ connections with Aurora for the sample streaming. The hardware could technically support such a configuration, but it would require extensive FPGA and host code development. I do not have a lot of familiarity with LabVIEW FPGA based workflows, but I would suggest looking into that as it is not impossible that that software stack could be made to support this. The base UHD and regular LabVIEW NI-USRP drivers do not support that set of configurations. Regards, Derek On Mon, Jul 31, 2017 at 2:22 PM, Nauman Iqbal via USRP-users < usrp-users@lists.ettus.com> wrote: > Hi, > > I am looking at the UHD’s initialization of radio parameters. Is > there a possibility if we can use the PCIe interface and Labview comms to > configure the radios and at same time configure the streamers to be using > 10gig Ethernet to send/receive baseband streams? So the configuration is > done totally independently via PCIe and a labiew GUI, plus we want to use > Aurora instead of the 10G Ethernet for the streamers. > > > > Regards > > > > Nauman > > _______________________________________________ > USRP-users mailing list > USRP-users@lists.ettus.com > http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com > >
_______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
