Hi hope this is the the right place to ask. I attempted an ip address change using the NI USRP utility tool and when changed the n210 fpga stopped being recognised by the computer. I am able to boot it in safe mode and the computer can contact the device (ping's okay, and uhd_find_devices is able to locate the fpga's on 192.168.10.2). but when I attempt to update the firmware and image it appears to work correctly but on cycling the power the devices disappears.
I have tried all the commands suggested in the ettus manual apart from debricking. I have two n210's and attempted to change defualt ip of one to 192.168.10.1 Computer interface set to 192.168.10.3 Subnet mask 255.255.255.0 Do you have any suggestions? Many thanks _______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
