my hostnodes to which this error came are are 10.1.255.254,10.1.255.236,10.1.255,241
On Thu, Apr 3, 2014 at 8:37 PM, Ralph Castain <r...@open-mpi.org> wrote: > I'm having trouble understanding your note, so perhaps I am getting this > wrong. Let's see if I can figure out what you said: > > * your perl command fails with "no route to host" - but I don't see any > host in your cmd. Maybe I'm just missing something. > > * you tried running a couple of "mpirun", but the mpirun command wasn't > recognized? Is that correct? > > * you then ran mpiblast and it sounds like it successfully started the > processes, but then one aborted? Was there an error message beyond just the > -1 return status? > > > On Apr 2, 2014, at 11:17 PM, Nisha Dhankher -M.Tech(CSE) < > nishadhankher-coaese...@pau.edu> wrote: > > error btl_tcp_endpint.c: 638 connection failed due to error > 113<http://biosupport.se/questions/696/error-btl_tcp_endpintc-638-connection-failed-due-to-error-113> > > In openmpi: this error came when i run my mpiblast program on rocks > cluster.Connect to hosts failed on ip 10.1.255.236,10.1.255.244 . And when > i run following command linux_shell$ perl -e 'die$!=113' this msg comes: > "No route to host at -e line 1." shell$ mpirun --mca btl ^tcp shell$ mpirun > --mca btl_tcp_if_include eth1,eth2 shell$ mpirun --mca btl_tcp_if_include > 10.1.255.244 was also executed but it did nt recognized these > commands....nd aborted.... what should i do...? When i run my mpiblast > program for the frst time then it give mpi_abort error...bailing out of > signal -1 on rank 2 processor...then i removed my public ethernet > cable....and then give btl_tcp endpint error 113.... > _______________________________________________ > users mailing list > us...@open-mpi.org > http://www.open-mpi.org/mailman/listinfo.cgi/users > > > > _______________________________________________ > users mailing list > us...@open-mpi.org > http://www.open-mpi.org/mailman/listinfo.cgi/users >
