On Mon, Jun 30, 2014 at 7:04 PM, Pete Travis <li...@petetravis.com> wrote:
> > On Jun 30, 2014 6:51 PM, "JD" <jd1...@gmail.com> wrote: > > > > > > On Mon, Jun 30, 2014 at 6:28 PM, Ed Greshko <ed.gres...@greshko.com> > wrote: > > > > > > On 07/01/14 08:11, JD wrote: > > > > > > Hi all, > > > When I run /sbin/system-config-services > > > I see that iptables is enabled, and that > > > /etc/sysconfig/iptables contains the rules > > > I want. > > > > > > However, after bootup, I open a terminal and > > > run iptables -L -n > > > and do not see those rules at all, and all > > > the rules are in "ACCEPT" state. > > > > > > I have to resort to start iptables manually > > > in order to install the rules I have in > > > /etc/sysconfig/iptables. > > > > > > So, what needs to be done to force iptables to run > > > and to use the rules I have in the iptables file? > > > > > > > > > > > > > > > > > > Directly after a reboot I would run.... > > > > > > systemctl status iptables.service > > > > > > And, yeah, your emails are a bit hard to read. > > > > > > > # systemctl status iptables.service > > iptables.service - IPv4 firewall with iptables > > Loaded: loaded (/usr/lib/systemd/system/iptables.service; enabled) > > Active: inactive (dead) > > > > # iptables -L -n .... > > > > -------------------------- > > > > What I have in /etc/sysconfig/iptables: > > # Firewall configuration written by system-config-firewall > > # Manual customization of this file is not recommended. > > *filter > > :INPUT > > ACCEPT[0:0] > > :FORWARD ACCEPT [0:0] > > :OUTPUT ACCEPT [0:0] > > -A INPUT -m state --state ESTABLISHED,RELATED -j ACCEPT > > -A INPUT -m state --state NEW -j DROP > > COMMIT > > > > -- > > > > Congrats, you've created a firewall ruleset just like the default, but > without ssh. You could have: > `firewall-cmd --remove-service ssh --permanent ` > > You can read about firewalld at https://fedoraproject.org/wiki/FirewallD > . If you prefer to disable firewalld and use iptables, there are > instructions on the same page. > > - > I am not familiar with firewalld (yet). But it was enbled by default, and I think that is what was the culprit, since I had not created any rulesets for it. I just disabled it, and will spend some time studying ruleset creation for it. By the way, why would I need a rule to allow sshd? I never ssh into my machine from other computers. Thanks for the heads up.
-- users mailing list users@lists.fedoraproject.org To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Fedora Code of Conduct: http://fedoraproject.org/code-of-conduct Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines Have a question? Ask away: http://ask.fedoraproject.org