As the subject line asks, where's the best place to discuss issues? The 3dprinting list ?
In the meantime, I've been using the released version of Cura on F28 but I couldn't seem to get a slice that had 1 layer wide vertical walls. So I thought I'd try the most recent version in F33 in a VM. [I then had to upgrade a system to F33 rather than in a VM.] After installing 'dnf install cura' and running it, it hangs with a splash screen that says: 'Welcome to Ultimaker Cura. Please follow these steps to set up Ultimaker Cura. This will only take a few moments.' And that's it. It does nothing else, and there isn't anything I can click on to proceed. Any suggestions? Thanks Fulko
_______________________________________________ users mailing list -- users@lists.fedoraproject.org To unsubscribe send an email to users-le...@lists.fedoraproject.org Fedora Code of Conduct: https://docs.fedoraproject.org/en-US/project/code-of-conduct/ List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines List Archives: https://lists.fedoraproject.org/archives/list/users@lists.fedoraproject.org
