On Mon, Jan 8, 2018 at 9:52 AM, InvalidPath <invalid.p...@gmail.com> wrote:
>
>
> On Mon, Jan 8, 2018 at 9:08 AM, Patrick O'Callaghan <pocallag...@gmail.com
> > wrote:
>
>> On Mon, 2018-01-08 at 08:56 -0700, InvalidPath wrote:
>> > So a bit of clarification: This 2TB Seagate was previously used at a
>> storage drive in a WIn10 system.. my old system from about 2 years back.
>> When I migrated to Fedora I kept it unmounted for quite a while until a
>> couple months ago. To be honest I cannot recall currently what it is
>> formatted as right now... I have a suspicion it's still NTFS just because I
>> have no other device to offload the data too in order to reformat as
>> something better. However I will verify that tonight. And no this disk is
>> a single huge partition.
>> > In addition it's not a green drive.. so there should be no spinning
>> down to save energy (that I know of).
>> >
>> > @Patrick, What you describe with your previous mounted NAS that is the
>> exact activity I see.
>>
>> [Please don't top-post in replies]
>>
>> You can check the state of the drive using smartctl before trying to
>> open a dialogue. It may be spinning down even if not 'green'.
>>
>> poc
>> _______________________________________________
>> users mailing list -- users@lists.fedoraproject.org
>> To unsubscribe send an email to users-le...@lists.fedoraproject.org
>>
>
>
>
> (Sorry)
> Ok good to know.. I'll check that this evening before actually trying to
> access the contents and see what's happening.
>
>
So smartctl showed me this:
18:56:41 skeer@sputnik ~/Downloads/cpuminer-multi ⬡ system linux
✔
$ sudo smartctl /dev/sda1 -a
smartctl 6.5 2016-05-07 r4318 [x86_64-linux-4.14.6-300.fc27.x86_64] (local
build)
Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Seagate Constellation ES.3
Device Model: ST2000NM0033-9ZM175
Serial Number: Z1Y398NP
LU WWN Device Id: 5 000c50 07ae22ab1
Firmware Version: SN04
User Capacity: 2,000,398,934,016 bytes [2.00 TB]
Sector Size: 512 bytes logical/physical
Rotation Rate: 7200 rpm
Form Factor: 3.5 inches
Device is: In smartctl database [for details use: -P show]
ATA Version is: ACS-2 (minor revision not indicated)
SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s)
Local Time is: Mon Jan 8 18:56:48 2018 MST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection:
Enabled.
Self-test execution status: ( 0) The previous self-test routine
completed
without error or no self-test has
ever
been run.
Total time to complete Offline
data collection: ( 584) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off
support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 223) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x50bd) SCT Status supported.
SCT Error Recovery Control
supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED
WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 082 063 044 Pre-fail Always
- 181005501
3 Spin_Up_Time 0x0003 095 094 000 Pre-fail Always
- 0
4 Start_Stop_Count 0x0032 100 100 020 Old_age Always
- 462
5 Reallocated_Sector_Ct 0x0033 100 100 010 Pre-fail Always
- 0
7 Seek_Error_Rate 0x000f 081 060 030 Pre-fail Always
- 154248700
9 Power_On_Hours 0x0032 085 085 000 Old_age Always
- 13343
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always
- 0
12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always
- 204
184 End-to-End_Error 0x0032 100 100 099 Old_age Always
- 0
187 Reported_Uncorrect 0x0032 100 100 000 Old_age Always
- 0
188 Command_Timeout 0x0032 100 100 000 Old_age Always
- 0
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always
- 0
190 Airflow_Temperature_Cel 0x0022 066 054 045 Old_age Always
- 34 (Min/Max 23/39)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always
- 0
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always
- 156
193 Load_Cycle_Count 0x0032 100 100 000 Old_age Always
- 959
194 Temperature_Celsius 0x0022 034 046 000 Old_age Always
- 34 (0 16 0 0 0)
195 Hardware_ECC_Recovered 0x001a 049 003 000 Old_age Always
- 181005501
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always
- 0
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline
- 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always
- 0
SMART Error Log Version: 1
No Errors Logged
SMART Self-test log structure revision number 1
No self-tests have been logged. [To run self-tests, use: smartctl -t]
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
>
_______________________________________________
users mailing list -- users@lists.fedoraproject.org
To unsubscribe send an email to users-le...@lists.fedoraproject.org
