On Wed, 9 Aug 2017 12:00:00 -0700 Rick Stevens <ri...@alldigital.com> wrote:
> On 08/09/2017 11:52 AM, D&R wrote: > > When I boot into the install there is an error in the destination section. > > > > I looked at the debug info in the storage.log and there was an > > error about sdb1 did not exist. But... > > > > When I reboot to F24 then ... > > > > cat /proc/mdstat > > > > md126 : active raid1 sda2[2] sdb2[1] > > 961261568 blocks super 1.2 [2/2] [UU] > > bitmap: 2/8 pages [8KB], 65536KB chunk > > > > md127 : active raid1 sdb1[1] sda1[2] > > 15368064 blocks super 1.0 [2/2] [UU] > > bitmap: 1/1 pages [4KB], 65536KB chunk > > > > The section of ks.cfg for hard drive setup is as follows: > > > > ignoredisk --only-use=sda,sdb > > bootloader --location=mbr --boot-drive=sda > > > > # Partition clearing information > > clearpart --none --initlabel > > > > # Disk partitioning information > > > > part raid.6 --fstype=mdmember --noformat --onpart=sda1 > > part raid.27 --fstype=mdmember --noformat --onpart=sdb1 > > part raid.14 --fstype=mdmember --noformat --onpart=sda2 > > part raid.32 --fstype=mdmember --noformat --onpart=sdb2 > > > > raid / --device=root --fstype=ext4 --level=raid1 --useexisting > > raid /home --device=home --fstype=ext4 --level=raid1 --noformat > > --useexisting > > > > I currently have a raid1 setup with 2 drives sda and sdb > > > > Since I am using the option --useexisting do I still need to use the part > > commands? > > > > The last time I did an upgrade was to F24 I have not found anything that > > says the syntax has changed. > > > > Any Ideas? > > Uhm, when you're booting the install, is it possible that the CD/DVD > you're booting from becomes /dev/sda? If so, then your first hard drive > is /dev/sdb and the second is /dev/sdc and the > > ignoredisk --only-use=sda,sdb > > would block using the second hard drive, since it's /dev/sdc at this > time. This is just a wild guess. I am booting from an iso file from another computer. As I recall that is what I did when I installed F24 over F22. In the setup above it shows raid.<number> (ie. raid.6). Do you know what the number represents? Can it be changed from one install to the next? David > ---------------------------------------------------------------------- > - Rick Stevens, Systems Engineer, AllDigital ri...@alldigital.com - > - AIM/Skype: therps2 ICQ: 226437340 Yahoo: origrps2 - > - - > - If your broker is so damned smart...why is he still working? - > ---------------------------------------------------------------------- > _______________________________________________ > users mailing list -- users@lists.fedoraproject.org > To unsubscribe send an email to users-le...@lists.fedoraproject.org _______________________________________________ users mailing list -- users@lists.fedoraproject.org To unsubscribe send an email to users-le...@lists.fedoraproject.org
