On Wed, 22 Jun 2016 08:03:48 +0000 David Aldrich <david.aldr...@emea.nec.com> wrote:
> With the new card removed, so just the onboard adaptor is present, > ifconfig -a just finds: > > lo > vibr0 > vibr0-nic > > and ethtool -i eno1 shows: > > "Cannot get driver information: no such device" Given the other information posted in this thread, and if it isn't turned off in the BIOS, if it was my machine, I would begin to suspect a hardware error. Is there any chance you zapped it with static when you were inside the machine installing the new card? Is there a lot of dust on the MB, perhaps creating a weak short malfunction? You could also try an older kernel. It's possible that the driver in the kernel has an error, but that's a pretty remote possibility. Try recreating the initramfs using dracut. Change the following command to reflect your system kernel parameters. You can find those by running ls while in /boot, and looking at the vmlinuz lines, or running uname -r. Run dracut while in /boot, and as root. It will replace your current initramfs with one customized for your system. Kernel install should already have done this, though. Then reboot. /usr/bin/dracut -f -H -v --debug initramfs-4.7.0-0.rc3.git3.1.20160619.fc25.x86_64.img 4.7.0-0.rc3.git3.1.20160619.fc25.x86_64 -- users mailing list users@lists.fedoraproject.org To unsubscribe or change subscription options: https://lists.fedoraproject.org/admin/lists/users@lists.fedoraproject.org Fedora Code of Conduct: http://fedoraproject.org/code-of-conduct Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines Have a question? Ask away: http://ask.fedoraproject.org
