You should install and configure your own turn server on the same
machine you run openmeetings. It's not difficult.
Regards.
El 27/4/20 a las 19:47, kaffeesurrogat escribió:
Should I setup my own machine or is it save to use a public one ?
On 27/04/2020 19:41, kaffeesurrogat wrote:
I didn't configure a STUN, is that the problem? Which server do you
recommend for being in germany ?
On 27/04/2020 19:25, kaffeesurrogat wrote:
Hey everybody,
i just finished a testing session with OM 5.0.4 and two colleages. It
didn't went well at all.
Quite a few error messages popped up in the middle of the session,
uploading of docx did not work, giving or withdrawing permissions to
draw on the white board did fail or failed not.
As my colleages logged in, they showed up twice in the user panel on the
right sight. I've been the moderator, my colleagues the "users".
After a short while and a couple of disconnections, I could not re-enter
the room because it was full. I've limited the room capacity to 6 people.
Restarting Openmeetings and KMS reentering the room for all of us,
cleared the problem for a short while.
The session was ended by a browser message, that the connection was
lost. I've attached the the logfile from this sessions. You will find
quite a few messages in there. I don't know, which one is really important,
thus I send all of them, replacing personal information .....
Many thanks in advance,
kaffeesurrogat
it is quite big, sorry for that ...
