Dear Easwar, In message <CANOwP4VriySb1xcf_Eyqt=vmzho6v0vqc4wxv7yko2dzxbx...@mail.gmail.com> you wrote: > > Im using a board similar to MPC8306SOM, We are using the same DDR, NOR,
Similar is not good enough. If there are _any_ differences, you must adapt U-Boot to these = port U-Boot to your hardware. There is no way around that. OK, you can close your eyes, pray to <indert your favorite deity here> and/or sacrifice a chicken - this may work, but more likely it doesn't. Or it appears to work, to fallon your feet all the harder a few steps further down the road. > When we google it, we saw many others facing the same issue as we are > facing. Kindly guide us in what needs to be done. You need to port U-Boot to your hardware. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de : I've tried (in vi) "g/[a-z]\n[a-z]/s//_/"...but that doesn't : cut it. Any ideas? (I take it that it may be a two-pass sort of solution). In the first pass, install perl. :-) Larry Wall <6...@jpl-devvax.jpl.nasa.gov> _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
