On 09/10/2012 12:35, Benoît Thébaudeau wrote: > Hi Stefano, > > On Monday, October 1, 2012 8:36:25 PM, Benoît Thébaudeau wrote: >> On mxc, each SDHC instance has a dedicated clock, so gd->sdhc_clk is >> not >> suitable for the multi-instance use case (initialization made >> directly with >> fsl_esdhc_initialize()). >> >> This patch fixes this issue by adding a configuration field for the >> SDHC input >> clock frequency. >> >> Signed-off-by: Benoît Thébaudeau <benoit.thebaud...@advansee.com> >> Cc: Stefano Babic <sba...@denx.de> >> Cc: Eric Bénard <e...@eukrea.com> >> Cc: Otavio Salvador <ota...@ossystems.com.br> >> Cc: Fabio Estevam <fabio.este...@freescale.com> >> Cc: Jason Liu <r64...@freescale.com> >> Cc: Matt Sealey <m...@genesi-usa.com> >> Cc: Andy Fleming <aflem...@gmail.com> >> --- >> This patch should be applied after (series of series...): >> http://patchwork.ozlabs.org/patch/187467/ >> http://patchwork.ozlabs.org/patch/187468/ >> http://patchwork.ozlabs.org/patch/187475/ >> >> This patch supersedes http://patchwork.ozlabs.org/patch/187476/ . >> >> Changes for v2: >> - Since this patch will go to /next, extend the original patch with >> the mxc >> boards newly added to this branch: mx6qsabreauto and mx6qsabresd. > > Did you forget to apply this patch (and > http://patchwork.ozlabs.org/patch/187468/ before it) when you applied my mx5 > and > mx25 clock series, or is it just still in your TODO list?
No, I did not forget. There are two patches for ESDHC. I wanted to be sure that PowerPC boards are not broken and I have rechecked it this morning. They are both ready in my queue to be merged. > If you could apply them before the Nitrogen6X series (in order to avoid a v3 > of > this patch), I'd be grateful ;) . But if you need more review/test time, of > course no problem if this is not possible. I have some patches ready to be merged, but I sent also a pull request for the -next branch, and it is not yet merged into arm-next. Anyway, I can modify my pull request including further patches, too. Best regards, Stefano -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
