Am 08/10/2012 23:58, schrieb Troy Kisky: > On 10/8/2012 6:54 AM, Stefano Babic wrote: >> On 05/10/2012 01:28, Troy Kisky wrote: >>> On 10/3/2012 8:00 PM, Otavio Salvador wrote: >>>> On Wed, Oct 3, 2012 at 10:47 PM, Troy Kisky >>>> <troy.ki...@boundarydevices.com> wrote: >>>>> The prompt is not appropriate if not running on >>>>> a mx6q processor. >>>>> >>>>> Signed-off-by: Troy Kisky <troy.ki...@boundarydevices.com> >>>> But in this case the board name will change, no? >>>> >>> No, patch 29/32 sets the new boards to use the same config file >>> (mx6qsabrelite.h) only adding ",MX6DL" or ",MX6S" or ",MX6Q" >>> to the end of the line in boards.cfg >> This means that CONFIG_MX6Dx is set. You can use it to set appropriately >> the prompt or use a more generic name including the board name, as >> "MX6SABRELITE U-Boot > ". The board is always the same, what is > > I can live with "MX6SABRELITE U-Boot" but I prefer a plain "U-Boot". > The rest seems a waste of screen real estate. The long u-boot commands > are more likely to wrap.
Personally agree, shorter is better. Regards, Stefano -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
