Hi Tom,
Am Donnerstag, den 13.09.2012, 14:00 -0700 schrieb Tom Warren:
[...]
>
> >> diff --git a/arch/arm/cpu/arm720t/tegra30/spl.c
> >> b/arch/arm/cpu/arm720t/tegra30/spl.c
> >
> >> +void board_init_f(ulong dummy)
> >> +{
> >> + board_init_uart_f();
> >> +
> >> + /* Initialize periph GPIOs */
> >> +#ifdef CONFIG_SPI_UART_SWITCH
> >> + gpio_early_init_uart();
> >> +#else
> >> + gpio_config_uart();
> >> +#endif
> >
> > Didn't we have patches to get rid of that mess and just use the same
> > function consistently across all boards, or was that only discussed and
> > never actually implemented?
>
> Someone on the list talked about a cleanup (Lucas? Thierry?), but,
> AFAIK, that never happened, or I would have put it in tegra/next. At
> the very least, it's not needed in Tegra30/spl.c, so I'll remove
> it/clean it up.
I did the cleanup and you in fact missed it in the last round of tegra/next.
Patch is called "tegra20: rework UART GPIO handling" and is already
acked-by Simon Glass.
Thanks,
Lucas
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
