Hi, All
Is any feedback for this rev3 patch series.
Best Regards,
Josh Wu
On 8/23/2012 6:05 PM, Josh Wu wrote:
This patch series will add PMECC support for atmel at91sam9x5ek in u-boot.
The NAND flash driver patch is ported from kernel patch. The main different
from kernel patch is
the modification about registers access part. in this version it via a register
structure to access.
It is tested in atmel AT919G25EK board.
Changes since v2:
adapt atmel nand driver to CONFIG_SYS_NAND_SELF_INIT. It use a new
board_nand_init(void) function.
Add README doc for Atmel PMECC.
Add timeout for PMECC read hw status.
refine code according to Andreas and Scott's comments.
Josh Wu (5):
at91: atmel_nand: extract HWECC initialization code into one
function: atmel_hw_nand_init_param().
at91: atmel_nand: remove unused variables.
at91: atmel_nand: Update driver to support Programmable Multibit ECC
controller
at91: 9x5: change SMC config timing that both works for PMECC &
non-PMECC.
at91: 9x5: Enable PMECC for 5series ek board.
board/atmel/at91sam9x5ek/at91sam9x5ek.c | 12 +-
doc/README.atmel_pmecc | 44 ++
drivers/mtd/nand/atmel_nand.c | 828 ++++++++++++++++++++++++++++---
drivers/mtd/nand/atmel_nand_ecc.h | 113 +++++
include/configs/at91sam9x5ek.h | 7 +
include/nand.h | 2 +-
6 files changed, 938 insertions(+), 68 deletions(-)
create mode 100644 doc/README.atmel_pmecc
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
