On Wed, Aug 22, 2012 at 12:04:27PM +0200, Christian Riesch wrote: > Hi Tom, > > On Mon, Aug 20, 2012 at 6:45 PM, Tom Rini <tr...@ti.com> wrote: > > - Convert the non-relocation part of board_init_f to spl_board_init, > > turn on CONFIG_SPL_BOARD_INIT in the configs. > > - Remove duplicated code. > > - Add spl_boot_device() that returns the statically chosen boot device. > > I tested the patchset on the LogicPD AM1808 experimenter's kit: > > make da850evm > and flashing to SPI flash with > mono sfh_OMAP-L138.exe -targetType AM1808 -p /dev/ttyUSB0 -flash_noubl > u-boot.ais
Confirmed, and I'll update the README to say that is how you can write the u-boot.ais in recovery mode. > The board boots up fine, but after pressing the reset button or > issuing the u-boot "reset" command, it is dead. Only power-cycling > helps. Before enabling the SPL framework in this patch reset works > fine. Any ideas? OK, I don't like the SPL malloc fix from before and I think it just masked, partially, a real problem. The SPI code did not change in the framework. And the very basic framework does not require malloc. I'm going to poke around and see what I can see, but more eyes would be welcome. -- Tom _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
