Dear Otavio Salvador,
> The elftosb call needs to use a target param specific for i.MX28. This
> patch allow for later addition of i.MX233.
>
> Signed-off-by: Otavio Salvador <ota...@ossystems.com.br>
> ---
> Makefile | 5 ++++-
> arch/arm/cpu/arm926ejs/mxs/{u-boot.bd => u-boot.bd.imx28} | 0
> 2 files changed, 4 insertions(+), 1 deletion(-)
> rename arch/arm/cpu/arm926ejs/mxs/{u-boot.bd => u-boot.bd.imx28} (100%)
>
> diff --git a/Makefile b/Makefile
> index f6471e2..5f11bb7 100644
> --- a/Makefile
> +++ b/Makefile
> @@ -452,8 +452,11 @@ $(obj)u-boot.ais: $(obj)spl/u-boot-spl.bin
> $(obj)u-boot.bin cat $(obj)spl/u-boot-spl-pad.ais $(obj)u-boot.bin > \
> $(obj)u-boot.ais
>
> +# Specify the target for use in elftosb call
> +ELFTOSB_TARGET-$(CONFIG_MX28) = imx28
> +
> $(obj)u-boot.sb: $(obj)u-boot.bin $(obj)spl/u-boot-spl.bin
> - elftosb -zdf imx28 -c $(TOPDIR)/$(CPUDIR)/$(SOC)/u-boot.bd \
> + elftosb -zdf $(ELFTOSB_TARGET-y) -c
> $(TOPDIR)/$(CPUDIR)/$(SOC)/u-boot.bd.$(ELFTOSB_TARGET-y) \ -o
> $(obj)u-boot.sb
Swap this to u-boot.$(ELFTOSB_TARGET-y).bd ... so the .bd suffix is always at
the end.
>
> # On x600 (SPEAr600) U-Boot is appended to U-Boot SPL.
> diff --git a/arch/arm/cpu/arm926ejs/mxs/u-boot.bd
> b/arch/arm/cpu/arm926ejs/mxs/u-boot.bd.imx28 similarity index 100%
> rename from arch/arm/cpu/arm926ejs/mxs/u-boot.bd
> rename to arch/arm/cpu/arm926ejs/mxs/u-boot.bd.imx28
Best regards,
Marek Vasut
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
