On 05/08/2012 09:34, Stefano Babic wrote:
> On 31/07/2012 21:21, Fabio Estevam wrote:
>> Define CONFIG_BOARD_LATE_INIT so that the serial console messages can be
>> redirected to the serial port.
>>
>> This is needed because in mx53loco.c we have:
>>
>> #ifdef CONFIG_BOARD_LATE_INIT
>> int board_late_init(void)
>> {
>> setenv("stdout", "serial");
>>
>> return 0;
>> }
>> #endif
>>
>> Signed-off-by: Fabio Estevam <fabio.este...@freescale.com>
>> ---
>> include/configs/mx53loco.h | 1 +
>> 1 files changed, 1 insertions(+), 0 deletions(-)
>>
>> diff --git a/include/configs/mx53loco.h b/include/configs/mx53loco.h
>> index 0a25c7d..bd23387 100644
>> --- a/include/configs/mx53loco.h
>> +++ b/include/configs/mx53loco.h
>> @@ -41,6 +41,7 @@
>> #define CONFIG_SYS_MALLOC_LEN (10 * 1024 * 1024)
>>
>> #define CONFIG_BOARD_EARLY_INIT_F
>> +#define CONFIG_BOARD_LATE_INIT
>
>
> Applied to u-boot-imx, thank.
>
> This is a real fix - board does not run without it. According to our
> discussion in the thread, dropping setenv("stdout", "serial") in code
> should be done in a separate patch.
Sorry Fabio - I was too fast. I thnked about and there is a better
solution. I drop your patch from u-boot-imx and I send a new on for
review, fixing the same issue.
Stefano
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
