On 31/07/2012 21:21, Fabio Estevam wrote:
> Define CONFIG_BOARD_LATE_INIT so that the serial console messages can be
> redirected to the serial port.
>
> This is needed because in mx53loco.c we have:
>
> #ifdef CONFIG_BOARD_LATE_INIT
> int board_late_init(void)
> {
> setenv("stdout", "serial");
>
> return 0;
> }
> #endif
>
> Signed-off-by: Fabio Estevam <fabio.este...@freescale.com>
> ---
> include/configs/mx53loco.h | 1 +
> 1 files changed, 1 insertions(+), 0 deletions(-)
>
> diff --git a/include/configs/mx53loco.h b/include/configs/mx53loco.h
> index 0a25c7d..bd23387 100644
> --- a/include/configs/mx53loco.h
> +++ b/include/configs/mx53loco.h
> @@ -41,6 +41,7 @@
> #define CONFIG_SYS_MALLOC_LEN (10 * 1024 * 1024)
>
> #define CONFIG_BOARD_EARLY_INIT_F
> +#define CONFIG_BOARD_LATE_INIT
Applied to u-boot-imx, thank.
This is a real fix - board does not run without it. According to our
discussion in the thread, dropping setenv("stdout", "serial") in code
should be done in a separate patch.
Best regards,
Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
