I have a new Zyxel NSA320. It is unmodified. At the uboot prompt I
printenv and save all environment variables. Next I pulled code from
https://github.com/psch2/uboot-nsa320, compiled and used kwboot to load
new uboot. No problems so far. Now if I reload all environment variables I
saved and boot the kernel loads but does not execute. Any ideas?
NSA320> boot
NAND read: device 0 offset 0xc80000, size 0xa00000
10485760 bytes read: OK
## Booting kernel from Legacy Image at 02000000 ...
Image Name: Linux-2.6.31.8
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 5909960 Bytes = 5.6 MiB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing
Linux...............................................................................................................................................................................................................................................................................
done, booting the kernel.
Richard
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
