Hi Gray, This wiki page might help you. http://www.denx.de/wiki/view/DULG/DecodingUBootCrashDumps
On 2012/07/11, at 22:08, Gary Thomas wrote: > I just tried rev 211e47549b668c7cdd8658c0413a272f0d0495d4 (v2012.07-rc1) > for my PandaBoard. Sadly, this is failing when I try to use the onboard > ethernet (EHCI USB based) controller: > > U-Boot SPL 2012.07-rc1 (Jul 11 2012 - 06:56:00) > OMAP4430 ES2.2 > OMAP SD/MMC: 0 > reading u-boot.img > reading u-boot.img > > > U-Boot 2012.07-rc1 (Jul 11 2012 - 06:56:00) > > CPU : OMAP4430 ES2.2 > Board: OMAP4 Panda > I2C: ready > DRAM: 1 GiB > MMC: OMAP SD/MMC: 0 > Using default environment > > In: serial > Out: serial > Err: serial > Net: No ethernet found. > Hit any key to stop autoboot: 0 > Panda # usb start > (Re)start USB... > USB: Register 1313 NbrPorts 3 > data abort > pc : [<bff9acb0>] lr : [<bff9ac91>] > sp : bff08e28 ip : 0000000f fp : 00000000 > r10: bff0a370 r9 : 00000002 r8 : bff08f68 > r7 : bffbb070 r6 : 00000000 r5 : bffaee04 r4 : 00001313 > r3 : bffaee04 r2 : 98000000 r1 : 0000000a r0 : 00000019 > Flags: Nzcv IRQs off FIQs off Mode SVC_32 > Resetting CPU ... > > Anyone else see this? Ideas? > > How do I map these addresses (PC=0xbff9acb0) to the ones in my > u-boot ELF image (so I can figure out what went wrong)? > > Thanks > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
