I just tried rev 211e47549b668c7cdd8658c0413a272f0d0495d4 (v2012.07-rc1) for my PandaBoard. Sadly, this is failing when I try to use the onboard ethernet (EHCI USB based) controller:
U-Boot SPL 2012.07-rc1 (Jul 11 2012 - 06:56:00) OMAP4430 ES2.2 OMAP SD/MMC: 0 reading u-boot.img reading u-boot.img U-Boot 2012.07-rc1 (Jul 11 2012 - 06:56:00) CPU : OMAP4430 ES2.2 Board: OMAP4 Panda I2C: ready DRAM: 1 GiB MMC: OMAP SD/MMC: 0 Using default environment In: serial Out: serial Err: serial Net: No ethernet found. Hit any key to stop autoboot: 0 Panda # usb start (Re)start USB... USB: Register 1313 NbrPorts 3 data abort pc : [<bff9acb0>] lr : [<bff9ac91>] sp : bff08e28 ip : 0000000f fp : 00000000 r10: bff0a370 r9 : 00000002 r8 : bff08f68 r7 : bffbb070 r6 : 00000000 r5 : bffaee04 r4 : 00001313 r3 : bffaee04 r2 : 98000000 r1 : 0000000a r0 : 00000019 Flags: Nzcv IRQs off FIQs off Mode SVC_32 Resetting CPU ... Anyone else see this? Ideas? How do I map these addresses (PC=0xbff9acb0) to the ones in my u-boot ELF image (so I can figure out what went wrong)? Thanks -- ------------------------------------------------------------ Gary Thomas | Consulting for the MLB Associates | Embedded world ------------------------------------------------------------ _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
