On 04/27/2012 09:17 AM, Wolfgang Denk wrote:
Dear Tom Rini,
In message<4f9ab2ee.3070...@ti.com> you wrote:
Argh... But you cannot change this without explicit ACK from the
respective board maintainers.
Then we're really SOL here. Even if we limit it to "I dropped
300/600/900/1200/2400/4800 baud rate support, is that ok".
What's wrong with keeping a customizes #define for the boards that use
nonstandard settings?
As I said in the commit message, I believe it was done for completeness
rather than need, but if you like I can change it to just delete
4800/9600/19200/38400/115200 (and reversed) and leave the rest alone.
And then I'll drop it from the boards I own :)
Finally, your patch does not apply (I guess it is an incremental patch
over obsolete code?).
That's odd actually, it was on v2012.04'ish and a pull and rebase -q
went quietly. It was build-tested on MAKEALL -a powerpc/arm/x86.
But you see the problem in the patch, don't you?
With it not applying? No...
--
Tom
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
