Dear Tom Rini, In message <4f9ab2ee.3070...@ti.com> you wrote: > > > Argh... But you cannot change this without explicit ACK from the > > respective board maintainers. > > Then we're really SOL here. Even if we limit it to "I dropped > 300/600/900/1200/2400/4800 baud rate support, is that ok".
What's wrong with keeping a customizes #define for the boards that use nonstandard settings? > > Finally, your patch does not apply (I guess it is an incremental patch > > over obsolete code?). > > That's odd actually, it was on v2012.04'ish and a pull and rebase -q > went quietly. It was build-tested on MAKEALL -a powerpc/arm/x86. But you see the problem in the patch, don't you? Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de "It follows that any commander in chief who undertakes to carry out a plan which he considers defective is at fault; he must put forth his reasons, insist of the plan being changed, and finally tender his resignation rather than be the instrument of his army's downfall." - Napoleon, "Military Maxims and Thought" _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
