On 4/9/12, Stefano Babic <sba...@denx.de> wrote: > The board revision is detected accessing to the pmic, > that is not available before relocation (I2C). > This generates the following error: > > CPU: Freescale i.MX35 rev 2.0 at 532 MHz. > Reset cause: WDOG > <reg num> = 7 is invalid. Should be less than 0 > Board: MX35 PDK 1.0 > > The revision number is wrong, as a default value is printed > (tested on a mx35pdk Rev. 2.0). > > Move the output in the board_late_init(), when > pmic can be accessed. > > Signed-off-by: Stefano Babic <sba...@denx.de> > --- > > V2: drop dead code > > board/freescale/mx35pdk/mx35pdk.c | 11 ----------- > include/configs/mx35pdk.h | 1 - > 2 files changed, 0 insertions(+), 12 deletions(-)
Looks like there is something wrong with this patch: 12 deletions and no insertions. Comparing it with v1 I would expect that only the "#if 0 and #endif" were removed. Regards, Fabio Estevam _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
