The board revision is detected accessing to the pmic,
that is not available before relocation (I2C).
This generates the following error:
CPU: Freescale i.MX35 rev 2.0 at 532 MHz.
Reset cause: WDOG
<reg num> = 7 is invalid. Should be less than 0
Board: MX35 PDK 1.0
The revision number is wrong, as a default value is printed
(tested on a mx35pdk Rev. 2.0).
Move the output in the board_late_init(), when
pmic can be accessed.
Signed-off-by: Stefano Babic <sba...@denx.de>
---
V2: drop dead code
board/freescale/mx35pdk/mx35pdk.c | 11 -----------
include/configs/mx35pdk.h | 1 -
2 files changed, 0 insertions(+), 12 deletions(-)
diff --git a/board/freescale/mx35pdk/mx35pdk.c
b/board/freescale/mx35pdk/mx35pdk.c
index cce7123..bc415b8 100644
--- a/board/freescale/mx35pdk/mx35pdk.c
+++ b/board/freescale/mx35pdk/mx35pdk.c
@@ -258,17 +258,6 @@ int board_late_init(void)
val |= 0x80;
mc9sdz60_reg_write(MC9SDZ60_REG_RESET_1, val);
- return 0;
-}
-
-int checkboard(void)
-{
- /*
- * Be sure that I2C is initialized to check
- * the board revision
- */
- i2c_init(CONFIG_SYS_I2C_SPEED, CONFIG_SYS_I2C_SLAVE);
-
/* Print board revision */
printf("Board: MX35 PDK %d.0\n", ((get_board_rev() >> 8) + 1) & 0x0F);
diff --git a/include/configs/mx35pdk.h b/include/configs/mx35pdk.h
index 1e03639..de4b954 100644
--- a/include/configs/mx35pdk.h
+++ b/include/configs/mx35pdk.h
@@ -34,7 +34,6 @@
#define CONFIG_MX35_HCLK_FREQ 24000000
#define CONFIG_DISPLAY_CPUINFO
-#define CONFIG_DISPLAY_BOARDINFO
/* Set TEXT at the beginning of the NOR flash */
#define CONFIG_SYS_TEXT_BASE 0xA0000000
--
1.7.5.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
