Dear Prafulla Wadaskar, > > -----Original Message----- > > From: Marek Vasut [mailto:ma...@denx.de] > > Sent: 21 March 2012 15:33 > > To: Prafulla Wadaskar > > Cc: Luka Perkov; u-boot@lists.denx.de; drea...@doukki.net; Wolfgang > > Denk > > Subject: Re: [U-Boot] [PATCH v2] add new board nas62x0 > > > > Dear Prafulla Wadaskar, > > ...snip... > > > > Hi Luka > > > > > > #1: Defining these values as 0xffffffff, indicates that all GPIOs > > > > are > > > > > configured high by default. so this configuration solely depends > > > > upon your > > > > > board requirement. > > > > > > #2: on kirkwood, you should define CONFIG_SKIP_LOWLEVEL_INIT since > > > lowlevel_init is not needed on Kirkwood platforms. (ref: > > > doc/README.kwbimage) > > > > Prafulla, you're then missing the fiddling with CPSR bits, which might > > be quite > > necessary. > > Hi Marek. > May be, may you please explain these bits? Or any pointers? Can't these be > addressed in kwimage.cfg?
I have no idea, I'm no kirkwood expert. And about these bits, check start.S, what it does with them. > > Regards.. > Prafulla . . . Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
