> -----Original Message----- > From: Marek Vasut [mailto:ma...@denx.de] > Sent: 21 March 2012 15:33 > To: Prafulla Wadaskar > Cc: Luka Perkov; u-boot@lists.denx.de; drea...@doukki.net; Wolfgang > Denk > Subject: Re: [U-Boot] [PATCH v2] add new board nas62x0 > > Dear Prafulla Wadaskar, ...snip... > > > > Hi Luka > > > > #1: Defining these values as 0xffffffff, indicates that all GPIOs > are > > configured high by default. so this configuration solely depends > upon your > > board requirement. > > > > #2: on kirkwood, you should define CONFIG_SKIP_LOWLEVEL_INIT since > > lowlevel_init is not needed on Kirkwood platforms. (ref: > > doc/README.kwbimage) > > Prafulla, you're then missing the fiddling with CPSR bits, which might > be quite > necessary.
Hi Marek. May be, may you please explain these bits? Or any pointers? Can't these be addressed in kwimage.cfg? Regards.. Prafulla . . . _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
