Hello Stephan I just checked it, and I am using v7 :) from: http://patchwork.ozlabs.org/bundle/rexut/net-ll_temac/ Once it is applied I will post the patches for xilinx-ppc440-generic (mainly instantiate it in the config...)
I have tried to download an image with the dhcp command over 100 and 1000M... I have to work more on it, but it looks promising. If you need an specific test, just say it, tomorrow I will be working with the board. Thanks again for the patch, it was very needed for u-boot. Regards On Thu, Dec 22, 2011 at 19:52, Stephan Linz <l...@li-pro.net> wrote: > Hello Recardo, > > Am Donnerstag, den 22.12.2011, 17:06 +0100 schrieb Ricardo Ribalda > Delgado: >> Hello Stefan, >> Hello Wolfgang, >> Hello Michal, >> >> I have tried the code on a Propietary Virtex5 fx board (ppc440) and it >> works.... Thanks for your work. > > OK, thanks for your efforts. Would it be possible for you to test even > the latest v7 patch? There were some critical changes between v6 and v7, > especially timeout regime, function pointers for plattform specific > in/out accessors, and MDIO clock calculation. > > > > -- > Best regards, > Stephan Linz > ______________________________________________________________________________ > MB-Ref: http://www.li-pro.de/xilinx_mb:mbref:start > OpenDCC: http://www.li-pro.net/opendcc.phtml > PC/M: http://www.li-pro.net/pcm.phtml > Sourceforge: http://sourceforge.net/users/slz > Gitorious: https://gitorious.org/~slz > -- Ricardo Ribalda _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
