On 11/28/2011 10:37 AM, Ilya Yanok wrote: > Currently nand_spl_simple puts it's temp data at 0x10000 offset in SDRAM > which is likely to contain already loaded data. I can't see any way to > determine some safe address automagically so make it up to board porter > to provide the safe-to-use address via CONFIG_SPL_NAND_WORKSPACE value. > > Signed-off-by: Ilya Yanok <ya...@emcraft.com> > --- > drivers/mtd/nand/nand_spl_simple.c | 7 ++++++- > 1 files changed, 6 insertions(+), 1 deletions(-) > > diff --git a/drivers/mtd/nand/nand_spl_simple.c > b/drivers/mtd/nand/nand_spl_simple.c > index ed821f2..70f3cfe 100644 > --- a/drivers/mtd/nand/nand_spl_simple.c > +++ b/drivers/mtd/nand/nand_spl_simple.c > @@ -199,8 +199,13 @@ static int nand_read_page(int block, int page, void *dst) > > /* No malloc available for now, just use some temporary locations > * in SDRAM > + * Please provide some safe value for CONFIG_SPL_NAND_WORKSPACE in > + * your board configuration, this is just a guess!! > */ > - ecc_calc = (u_char *)(CONFIG_SYS_SDRAM_BASE + 0x10000); > +#ifndef CONFIG_SPL_NAND_WORKSPACE > +#define CONFIG_SPL_NAND_WORKSPACE (CONFIG_SYS_SDRAM_BASE + 0x10000) > +#endif > + ecc_calc = (u_char *)CONFIG_SPL_NAND_WORKSPACE; > ecc_code = ecc_calc + 0x100; > oob_data = ecc_calc + 0x200; >
Please document this config symbol in README. -Scott _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
