On 11/07/2011 08:59 AM, Helmut Raiger wrote: > On 11/02/2011 08:02 AM, Helmut Raiger wrote: >> On 10/27/2011 02:19 PM, Helmut Raiger wrote: >>> This patch modifies mxcmmc.c to be used >>> not only by i.MX27 but also by i.MX31 boards. >>> Both use the same SD controller, but have different >>> clock set-ups. >>> The i.MX27 imx_get_XXXclock functions are made static to >>> generic.c and a public mxc_get_clock() function >>> is provided. Pins, base address and prototypes for >>> an i.MX31 specific board_init_mmc() are provided. >>> Some of the i.MX27 clock getters are unused and marked >>> as such to avoid warnings (./MAKEALL -s mx27), but >>> the code was left in for future use. >>> >>> Signed-off-by: Helmut Raiger<helmut.rai...@hale.at> >> >> I just re-titled the patch to make it visible for the imx community, >> it concerns i.MX27 and i.MX31, so mmc: is probably the wrong >> category anyway. >> >> Helmut
Hi Helmut, > Anything amiss? > Helmut I have seen your message regarding your patch "tt01: add MMC and video support" asking to ignore it, and I have ignored this patch, too.... I will review it soo - however, there is no use case for MMC on the i.MX31 until you submit a patch for your board supporting MMC. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
