I did tests with OMAP3 uboot. The SW-ECC (testet 1 bit, 4 bit BCH) doesn't correct errors in environment (during power-up). Compiling uboot for default HW-ECC - correction works fine. Testet with TI's PSP 4.02.00.07 (almost like arago latest version).
I modified single bits by adding a patch (thanks Scott Wood) to uboot, that allows write in raw mode to flash. Single bit error can corrected with HW-ECC, not with SW-ECC. This report is only about uboot environment, which is read in startup. I didn't test it, but from my experience the correction works fine, beside the initial reading of the environment, as for reading and starting the kernel. Imho this is very critical, as reliability is suffered if a device isn't booting. Best regards Arno PS: The link below refers to a previous discussion. http://lists.denx.de/pipermail/u-boot/2011-September/100486.html in omap_gpmc.c I used this in board_nand_init() ... nand->chip_delay = 100; nand->ecc.mode = NAND_ECC_4BIT_SOFT; nand_curr_device = 0; omap_nand_switch_ecc(NAND_ECC_4BIT_SOFT, 1); return 0; } _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
