From: Nagabhushana Netagunte <nagabhushana.netagu...@ti.com>
da830 boards have mac address stored in I2C EEPROM. This patch
adds support to restore mac address from EEPROM if environment variable
'ethaddr' is not set.
Signed-off-by: Sudhakar Rajashekhara <sudhakar....@ti.com>
Signed-off-by: Nagabhushana Netagunte <nagabhushana.netagu...@ti.com>
---
board/davinci/da8xxevm/da830evm.c | 20 ++++++++++++++++++++
include/configs/da830evm.h | 1 +
2 files changed, 21 insertions(+), 0 deletions(-)
diff --git a/board/davinci/da8xxevm/da830evm.c
b/board/davinci/da8xxevm/da830evm.c
index 0650653..69ed293 100644
--- a/board/davinci/da8xxevm/da830evm.c
+++ b/board/davinci/da8xxevm/da830evm.c
@@ -188,6 +188,26 @@ int board_init(void)
#define PHY_SW_I2C_ADDR 0x5f /* Address of PHY on i2c bus */
+int misc_init_r(void)
+{
+ uint8_t eeprom_enetaddr[6];
+ uint8_t val[2];
+
+ if (!eth_getenv_enetaddr("ethaddr", eeprom_enetaddr)) {
+ /* Read Ethernet MAC address from EEPROM if available. */
+ if (dvevm_read_mac_address(eeprom_enetaddr))
+ /* Set Ethernet MAC address from EEPROM */
+ davinci_sync_env_enetaddr(eeprom_enetaddr);
+ }
+
+ val[0] = 0x01;
+ val[1] = 0x23;
+
+ if (i2c_write(PHY_SW_I2C_ADDR, 0, 0, val, 2))
+ printf("Ethernet switch start failed!\n");
+
+}
+
/*
* Initializes on-board ethernet controllers.
*/
diff --git a/include/configs/da830evm.h b/include/configs/da830evm.h
index 66fdea2..a451513 100644
--- a/include/configs/da830evm.h
+++ b/include/configs/da830evm.h
@@ -160,6 +160,7 @@
/*
* U-Boot general configuration
*/
+#define CONFIG_MISC_INIT_R
#undef CONFIG_USE_IRQ /* No IRQ/FIQ in U-Boot */
#undef CONFIG_MISC_INIT_R
#undef CONFIG_BOOTDELAY
--
1.6.2.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
