Hi Joel, The current release (based on u-boot-ti) is V9: http://patchwork.ozlabs.org/bundle/Simon/OMAP3_SPL_V9/
Or V10 http://mid.gmane.org/1315949258-12064-1-git-send-email-tr...@ti.com (based on u-boot-arm) Actually this may already work (although I haven't tested it yet). If you define CONFIG_SPL_MMC_SUPPORT and CONFIG_SPL_NAND_SUPPORT (plus the necessary defines for them) in your board header it is looking for the bootdevice the ROM code used and tries to load the image from it. If you try MMC with OMAP3 I would appreciate a message if it works or not. Regards Simon On 09/16/2011 08:11 AM, Joel A Fernandes wrote: > Hi Simon, > > Great work on the SPL patches for omap. I am getting a bit familiar > with this and earlier SPL work. > > Just one question about one of your patches I happen to notice [1], > why is there a SPL build for each different boot mode such as for > NAND, MMC etc?. Wouldn't it be nicer to have a single SPL loader that > tried different boot modes one after the other, something like what > x-load already does? Are there are any challenges with this approach? > > Thanks! > Joel _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
