Hi, first thing would be to use a current U-Boot Version. This can be obtained from: http://www.denx.de/wiki/U-Boot/SourceCode
Regards Simon On 09/15/2011 03:31 PM, Chaney Lee wrote: > hello: > > I need your advise. > I port the u-boot-1.3.3 to my PXA270 board。Every thing works well but the > SMC91111 dirver.I have aready config the config file like this: > #define CONFIG_DRIVER_SMC91111 1 > #define CONFIG_SMC91111_BASE 0x10000300 > #define CONFIG_SMC91111_EXT_PHY > > #define CONFIG_SMC_USE_32_BIT 1 > Then I use PING command to my host and the minicom shows the host is not > alive.But I am sure the host is right because I had PING the host ,which is > in VMware. > And after I turn on the DEBUG of SMC91111.c to 5 ,I get the message.Here > are part of them. > > SMC91111: smc_hardware_send_packet > SMC91111: memory allocation, try 1 failed ... > SMC91111: memory allocation, try 2 failed ... > SMC91111: memory allocation, try 3 failed ... > SMC91111: memory allocation, try 4 failed ... > SMC91111: memory allocation, try 5 failed ... > > So how can I fix this problem?Can you give me some suggestions? > ps:my u-boot run in RAM and boot from BLOB.Then the u-boot.bin skip the > lowlevel_init function. > > Thank you ! > > > > > _______________________________________________ > U-Boot mailing list > U-Boot@lists.denx.de > http://lists.denx.de/mailman/listinfo/u-boot _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
