On Aug 31, 2011, at 5:15 PM, Timur Tabi wrote:

> Most 85xx boards can be built as a 32-bit or a 36-bit.  Current code sometimes
> displays which of these is actually built, but it's inconsistent.  This is
> especially problematic since the "default" build for a given 85xx board can
> be either one, so if you don't see a message, you can't always know which
> size is being used.  Not only that, but each board includes code that displays
> the message, so there is duplication.
> 
> So if a given SOC can support 36-bit addresses, display one of these two
> messages during boot:
> 
>       ADDR:  32-bit address map
> 
> or
> 
>       ADDR:  36-bit address map
> 
> Also delete the board-specific code that does this.
> 
> Signed-off-by: Timur Tabi <ti...@freescale.com>
> ---
> arch/powerpc/cpu/mpc85xx/cpu_init.c         |   12 ++++++++++++
> board/freescale/corenet_ds/corenet_ds.c     |    4 ----
> board/freescale/mpc8536ds/mpc8536ds.c       |    7 +------
> board/freescale/mpc8572ds/mpc8572ds.c       |    6 +-----
> board/freescale/p1010rdb/p1010rdb.c         |    6 +-----
> board/freescale/p1022ds/p1022ds.c           |    8 ++------
> board/freescale/p1_p2_rdb/p1_p2_rdb.c       |    4 +---
> board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c |    8 +-------
> board/freescale/p2020ds/p2020ds.c           |    8 ++------
> board/freescale/p2041rdb/p2041rdb.c         |    4 ----
> 10 files changed, 21 insertions(+), 46 deletions(-)
> 
> diff --git a/arch/powerpc/cpu/mpc85xx/cpu_init.c 
> b/arch/powerpc/cpu/mpc85xx/cpu_init.c
> index 27f836c..d691726 100644
> --- a/arch/powerpc/cpu/mpc85xx/cpu_init.c
> +++ b/arch/powerpc/cpu/mpc85xx/cpu_init.c
> @@ -302,6 +302,18 @@ int cpu_init_r(void)
>       sync();
> #endif
> 
> +     /*
> +      * If we support 36-bit addressing, then display whether this is a
> +      * 32-bit build or a 36-bit build.
> +      */
> +#ifdef CONFIG_ENABLE_36BIT_PHYS
> +#ifdef CONFIG_PHYS_64BIT

#if defined(A) && defined(B)

> +     puts("ADDR:  36-bit address map\n");
> +#else
> +     puts("ADDR:  32-bit address map\n");
> +#endif
> +#endif
> +
>       puts ("L2:    ");
> 
> #if defined(CONFIG_L2_CACHE)

Wolfgang's being making comments about reducing the boot info we've been 
outputting so would like his 2 cents on this.

- k
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to