Dear Andreas, On 07/26/2011 07:59 AM, Andreas Bießmann wrote: > Dear Simon, > > Am 25.07.2011 um 20:05 schrieb Simon Schwarz: > >> Insert some NAND driver sources into NAND SPL library. >> >> --- >> V1 changes: >> CHG Default to HW ecc in SPL build >> ADD nand_read_buf16 function, read buffer >> ADD omap_dev_ready function, indicte if chip is ready >> >> V2 changes: >> DEL GPMC_WAIT0_PIN_ACTIVE define >> CHG omap_dev_ready() renamed to omap_spl_dev_ready(), does not use the >> GPMC_WAIT0_PIN_ACTIVE-define anymore >> CHG ogpmc_read_buf16 renamed omap_spl_read_buf16 >> ADD omap_spl_read_buf, 8x buf read function >> ADD CONFIG_SPL_POWER_SUPPORT and CONFIG_SPL_NAND_SUPPORT to SPL >> CHG cosmetic >> CHG nand_base and nand_bbt aren't needed for SPL anymore >> CHG omap_nand_switch_ecc is not compiled for SPL >> ADD entry for CONFIG_SPL_POWER_SUPPORT and CONFIG_SPL_NAND_SUPPORT to >> README.SPL >> >> Transition from V1 to V2 also includes that this patch is now based on >> - the new SPL layout by Aneesh V and Daniel Schwierzeck >> - the OMAP4 SPL patches by Aneesh V >> >> This Patch is related to "[U-Boot,4/5] devkit8000 nand_spl: Add SPL NAND >> support >> to omap_gpmc driver" >> (http://article.gmane.org/gmane.comp.boot-loaders.u-boot/102115) in V1 >> >> Signed-off-by: Simon Schwarz<simonschwarz...@gmail.com> >> --- >> doc/README.SPL | 2 + >> drivers/mtd/nand/Makefile | 6 +++- >> drivers/mtd/nand/omap_gpmc.c | 69 >> ++++++++++++++++++++++++++++++++++++++++++ >> spl/Makefile | 2 + >> 4 files changed, 78 insertions(+), 1 deletions(-) > > <snip> > >> --- a/drivers/mtd/nand/omap_gpmc.c >> +++ b/drivers/mtd/nand/omap_gpmc.c >> @@ -61,6 +61,55 @@ static void omap_nand_hwcontrol(struct mtd_info *mtd, >> int32_t cmd, >> writeb(cmd, this->IO_ADDR_W); >> } > > <snip> > >> @@ -224,6 +273,8 @@ static void omap_enable_hwecc(struct mtd_info *mtd, >> int32_t mode) >> } >> } >> >> + > > This single line is unnecessary. deleted... > >> +#ifndef CONFIG_SPL_BUILD >> /* >> * omap_nand_switch_ecc - switch the ECC operation b/w h/w ecc and s/w ecc. >> * The default is to come up on s/w ecc >> @@ -280,6 +331,7 @@ void omap_nand_switch_ecc(int32_t hardware) >> > > regards > > Andreas Bießmann
regards Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
