Import drivers/usb/host/xhci-ext-caps.h from Linux v6.16-rc7. The file is needed by the updated DWC3 code.
Signed-off-by: Jerome Forissier <[email protected]> --- drivers/usb/host/xhci-ext-caps.h | 158 +++++++++++++++++++++++++++++++ 1 file changed, 158 insertions(+) create mode 100644 drivers/usb/host/xhci-ext-caps.h diff --git a/drivers/usb/host/xhci-ext-caps.h b/drivers/usb/host/xhci-ext-caps.h new file mode 100644 index 000000000000..fd23eda6f616 --- /dev/null +++ b/drivers/usb/host/xhci-ext-caps.h @@ -0,0 +1,158 @@ +/* SPDX-License-Identifier: GPL-2.0 */ +/* Imported from Linux v6.16-rc7 */ +/* + * xHCI host controller driver + * + * Copyright (C) 2008 Intel Corp. + * + * Author: Sarah Sharp + * Some code borrowed from the Linux EHCI driver. + */ + +/* HC should halt within 16 ms, but use 32 ms as some hosts take longer */ +#define XHCI_MAX_HALT_USEC (32 * 1000) +/* HC not running - set to 1 when run/stop bit is cleared. */ +#define XHCI_STS_HALT (1<<0) + +/* HCCPARAMS offset from PCI base address */ +#define XHCI_HCC_PARAMS_OFFSET 0x10 +/* HCCPARAMS contains the first extended capability pointer */ +#define XHCI_HCC_EXT_CAPS(p) (((p)>>16)&0xffff) + +/* Command and Status registers offset from the Operational Registers address */ +#define XHCI_CMD_OFFSET 0x00 +#define XHCI_STS_OFFSET 0x04 + +#define XHCI_MAX_EXT_CAPS 50 + +/* Capability Register */ +/* bits 7:0 - how long is the Capabilities register */ +#define XHCI_HC_LENGTH(p) (((p)>>00)&0x00ff) + +/* Extended capability register fields */ +#define XHCI_EXT_CAPS_ID(p) (((p)>>0)&0xff) +#define XHCI_EXT_CAPS_NEXT(p) (((p)>>8)&0xff) +#define XHCI_EXT_CAPS_VAL(p) ((p)>>16) +/* Extended capability IDs - ID 0 reserved */ +#define XHCI_EXT_CAPS_LEGACY 1 +#define XHCI_EXT_CAPS_PROTOCOL 2 +#define XHCI_EXT_CAPS_PM 3 +#define XHCI_EXT_CAPS_VIRT 4 +#define XHCI_EXT_CAPS_ROUTE 5 +/* IDs 6-9 reserved */ +#define XHCI_EXT_CAPS_DEBUG 10 +/* Vendor caps */ +#define XHCI_EXT_CAPS_VENDOR_INTEL 192 +#define XHCI_EXT_CAPS_INTEL_SPR_SHADOW 206 +/* USB Legacy Support Capability - section 7.1.1 */ +#define XHCI_HC_BIOS_OWNED (1 << 16) +#define XHCI_HC_OS_OWNED (1 << 24) + +/* USB Legacy Support Capability - section 7.1.1 */ +/* Add this offset, plus the value of xECP in HCCPARAMS to the base address */ +#define XHCI_LEGACY_SUPPORT_OFFSET (0x00) + +/* USB Legacy Support Control and Status Register - section 7.1.2 */ +/* Add this offset, plus the value of xECP in HCCPARAMS to the base address */ +#define XHCI_LEGACY_CONTROL_OFFSET (0x04) +/* bits 1:3, 5:12, and 17:19 need to be preserved; bits 21:28 should be zero */ +#define XHCI_LEGACY_DISABLE_SMI ((0x7 << 1) + (0xff << 5) + (0x7 << 17)) +#define XHCI_LEGACY_SMI_EVENTS (0x7 << 29) + +/* USB 2.0 xHCI 0.96 L1C capability - section 7.2.2.1.3.2 */ +#define XHCI_L1C (1 << 16) + +/* USB 2.0 xHCI 1.0 hardware LMP capability - section 7.2.2.1.3.2 */ +#define XHCI_HLC (1 << 19) +#define XHCI_BLC (1 << 20) + +/* Intel SPR shadow capability */ +#define XHCI_INTEL_SPR_ESS_PORT_OFFSET 0x8ac4 /* SuperSpeed port control */ +#define XHCI_INTEL_SPR_TUNEN BIT(4) /* Tunnel mode enabled */ + +/* command register values to disable interrupts and halt the HC */ +/* start/stop HC execution - do not write unless HC is halted*/ +#define XHCI_CMD_RUN (1 << 0) +/* Event Interrupt Enable - get irq when EINT bit is set in USBSTS register */ +#define XHCI_CMD_EIE (1 << 2) +/* Host System Error Interrupt Enable - get irq when HSEIE bit set in USBSTS */ +#define XHCI_CMD_HSEIE (1 << 3) +/* Enable Wrap Event - '1' means xHC generates an event when MFINDEX wraps. */ +#define XHCI_CMD_EWE (1 << 10) + +#define XHCI_IRQS (XHCI_CMD_EIE | XHCI_CMD_HSEIE | XHCI_CMD_EWE) + +/* true: Controller Not Ready to accept doorbell or op reg writes after reset */ +#define XHCI_STS_CNR (1 << 11) + +/** + * struct xhci_protocol_caps + * @revision: major revision, minor revision, capability ID, + * and next capability pointer. + * @name_string: Four ASCII characters to say which spec this xHC + * follows, typically "USB ". + * @port_info: Port offset, count, and protocol-defined information. + */ +struct xhci_protocol_caps { + u32 revision; + u32 name_string; + u32 port_info; +}; + +#define XHCI_EXT_PORT_MAJOR(x) (((x) >> 24) & 0xff) +#define XHCI_EXT_PORT_MINOR(x) (((x) >> 16) & 0xff) +#define XHCI_EXT_PORT_PSIC(x) (((x) >> 28) & 0x0f) +#define XHCI_EXT_PORT_OFF(x) ((x) & 0xff) +#define XHCI_EXT_PORT_COUNT(x) (((x) >> 8) & 0xff) + +#define XHCI_EXT_PORT_PSIV(x) (((x) >> 0) & 0x0f) +#define XHCI_EXT_PORT_PSIE(x) (((x) >> 4) & 0x03) +#define XHCI_EXT_PORT_PLT(x) (((x) >> 6) & 0x03) +#define XHCI_EXT_PORT_PFD(x) (((x) >> 8) & 0x01) +#define XHCI_EXT_PORT_LP(x) (((x) >> 14) & 0x03) +#define XHCI_EXT_PORT_PSIM(x) (((x) >> 16) & 0xffff) + +#include <linux/io.h> + +/** + * Find the offset of the extended capabilities with capability ID id. + * + * @base PCI MMIO registers base address. + * @start address at which to start looking, (0 or HCC_PARAMS to start at + * beginning of list) + * @id Extended capability ID to search for, or 0 for the next + * capability + * + * Returns the offset of the next matching extended capability structure. + * Some capabilities can occur several times, e.g., the XHCI_EXT_CAPS_PROTOCOL, + * and this provides a way to find them all. + */ + +static inline int xhci_find_next_ext_cap(void __iomem *base, u32 start, int id) +{ + u32 val; + u32 next; + u32 offset; + + offset = start; + if (!start || start == XHCI_HCC_PARAMS_OFFSET) { + val = readl(base + XHCI_HCC_PARAMS_OFFSET); + if (val == ~0) + return 0; + offset = XHCI_HCC_EXT_CAPS(val) << 2; + if (!offset) + return 0; + } + do { + val = readl(base + offset); + if (val == ~0) + return 0; + if (offset != start && (id == 0 || XHCI_EXT_CAPS_ID(val) == id)) + return offset; + + next = XHCI_EXT_CAPS_NEXT(val); + offset += next << 2; + } while (next); + + return 0; +} -- 2.48.1
