On Tue, Jun 21, 2011 at 6:33 PM, Rob Herring <[email protected]> wrote:
> From: Rob Herring <[email protected]>
>
> Add basic support for Calxeda Highbank platform. Only minimal support to boot
> is included.
>
> Signed-off-by: Jason Hobbs <[email protected]>
> Signed-off-by: Rob Herring <[email protected]>
> Cc: Albert ARIBAUD <[email protected]>
> ---
> arch/arm/cpu/armv7/highbank/Makefile | 46 ++++++++++++
> arch/arm/cpu/armv7/highbank/config.mk | 4 +
> arch/arm/cpu/armv7/highbank/timer.c | 124
> +++++++++++++++++++++++++++++++++
> board/highbank/Makefile | 49 +++++++++++++
> board/highbank/highbank.c | 49 +++++++++++++
> boards.cfg | 1 +
> include/configs/highbank.h | 101 +++++++++++++++++++++++++++
You should add an entry to MAINTAINERS file.
...
> +int dram_init(void)
> +{
> + gd->ram_size = SZ_512M;
You could use
gd->ram_size = get_ram_size((volatile void *)PHYS_SDRAM_1, PHYS_SDRAM_1_SIZE);
Regards,
Fabio Estevam
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
