Enable basic EFI debug features, switch over to stdboot, enable GPIO, LED and PMIC used on this platform. And enable UHS mode support for SD cards in U-Boot.
Unlike other BeagleBoard products, BeagleY-AI does not have alternative onboard non-volatile memories, so capsule support does not make sense. Acked-by: Andrew Davis <a...@ti.com> Signed-off-by: Nishanth Menon <n...@ti.com> --- Changes Since v2: - None V2: https://lore.kernel.org/r/20250418193943.953952-9...@ti.com configs/am67a_beagley_ai_a53_defconfig | 12 +++++++++++- 1 file changed, 11 insertions(+), 1 deletion(-) diff --git a/configs/am67a_beagley_ai_a53_defconfig b/configs/am67a_beagley_ai_a53_defconfig index cbf19a03b136..9a5172cda1f3 100644 --- a/configs/am67a_beagley_ai_a53_defconfig +++ b/configs/am67a_beagley_ai_a53_defconfig @@ -32,7 +32,7 @@ CONFIG_AUTOBOOT_KEYED=y CONFIG_AUTOBOOT_PROMPT="Press SPACE to abort autoboot in %d seconds\n" CONFIG_AUTOBOOT_DELAY_STR="d" CONFIG_AUTOBOOT_STOP_STR=" " -CONFIG_BOOTCOMMAND="run findfdt; run envboot; run distro_bootcmd" +CONFIG_BOOTCOMMAND="run set_led_state_start_load; run envboot; bootflow scan -lb; run set_led_state_fail_load" CONFIG_BOARD_LATE_INIT=y CONFIG_SPL_MAX_SIZE=0x58000 CONFIG_SPL_PAD_TO=0x0 @@ -49,7 +49,9 @@ CONFIG_SPL_RAM_DEVICE=y CONFIG_SPL_THERMAL=y CONFIG_SPL_YMODEM_SUPPORT=y CONFIG_CMD_CLK=y +CONFIG_CMD_GPIO_READ=y CONFIG_CMD_USB_MASS_STORAGE=y +CONFIG_CMD_EFIDEBUG=y CONFIG_OF_CONTROL=y CONFIG_SPL_OF_CONTROL=y CONFIG_OF_UPSTREAM=y @@ -81,6 +83,10 @@ CONFIG_SPL_DM_GPIO_LOOKUP_LABEL=y CONFIG_DA8XX_GPIO=y CONFIG_DM_I2C=y CONFIG_SYS_I2C_OMAP24XX=y +CONFIG_LED=y +CONFIG_SPL_LED=y +CONFIG_LED_GPIO=y +CONFIG_SPL_LED_GPIO=y CONFIG_DM_MAILBOX=y CONFIG_K3_SEC_PROXY=y CONFIG_I2C_EEPROM=y @@ -88,6 +94,7 @@ CONFIG_SPL_I2C_EEPROM=y CONFIG_FS_LOADER=y CONFIG_MMC_IO_VOLTAGE=y CONFIG_SPL_MMC_IO_VOLTAGE=y +CONFIG_MMC_UHS_SUPPORT=y CONFIG_MMC_SDHCI=y CONFIG_MMC_SDHCI_ADMA=y CONFIG_SPL_MMC_SDHCI_ADMA=y @@ -99,12 +106,15 @@ CONFIG_SPL_PINCTRL=y CONFIG_PINCTRL_SINGLE=y CONFIG_POWER_DOMAIN=y CONFIG_TI_SCI_POWER_DOMAIN=y +CONFIG_DM_PMIC=y +CONFIG_PMIC_TPS65219=y CONFIG_DM_REGULATOR=y CONFIG_SPL_DM_REGULATOR=y CONFIG_DM_REGULATOR_FIXED=y CONFIG_SPL_DM_REGULATOR_FIXED=y CONFIG_DM_REGULATOR_GPIO=y CONFIG_SPL_DM_REGULATOR_GPIO=y +CONFIG_DM_REGULATOR_TPS65219=y CONFIG_K3_SYSTEM_CONTROLLER=y CONFIG_RESET_TI_SCI=y CONFIG_DM_SERIAL=y -- 2.47.0
