Provide the settings for using the debug UART in SPL.
Signed-off-by: Heinrich Schuchardt <heinrich.schucha...@canonical.com>
---
v3:
no change
v2:
new patch
---
doc/board/starfive/jh7110_common.rst | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/doc/board/starfive/jh7110_common.rst
b/doc/board/starfive/jh7110_common.rst
index 44ccd612ff4..3c939d50de7 100644
--- a/doc/board/starfive/jh7110_common.rst
+++ b/doc/board/starfive/jh7110_common.rst
@@ -64,3 +64,17 @@ u-boot.itb via the Y-modem protocol.
Due to restrictions of the boot ROM not all X-modem implementations are
compatible. The package tio (https://github.com/tio/tio) has been found to be
usable.
+
+Debug UART
+----------
+
+By default the SBI interface is used for the debug UART. But this only works
+in main U-Boot. To enable the debug UART in SPL, too, use the following
+settings::
+
+ CONFIG_DEBUG_UART=y
+ CONFIG_DEBUG_UART_NS16550=y
+ CONFIG_DEBUG_UART_BASE=0x10000000
+ CONFIG_SPL_DEBUG_UART_BASE=0x10000000
+ CONFIG_DEBUG_UART_CLOCK=24000000
+ CONFIG_DEBUG_UART_SHIFT=2
--
2.48.1
