Hello Aniket,
On 10.03.25 11:36, Aniket Limaye wrote:
Repeated Start Condition (Sr) can be used to transfer multiple i2c msgs
without sending a Stop condition (P). So far, the driver default was to
always send a Stop condition after every i2c msg.
Add support for a config option (CONFIG_SYS_I2C_OMAP24XX_REPEATED_START)
to disable sending the Stop condition by default. If this config is
enabled, Stop condition will be sent only if explicitly requested in the
msg flags OR if it is the last msg in the transfer.
Consequently, handle the Repeated Start condition (Sr) in the next msg
by not calling the wait_for_bb() check since it will simply timeout in
the absence of a stop condition (BB will be 1 until Stop is programmed)
Signed-off-by: Aniket Limaye <a-lim...@ti.com>
---
v2:
- fixup code formatting and comment blocks
- CONFIG_I2C_REPEATED_START -> CONFIG_SYS_I2C_OMAP24XX_REPEATED_START
- Link to v1:
https://lore.kernel.org/u-boot/20250304220546.866602-3-a-lim...@ti.com/
---
drivers/i2c/omap24xx_i2c.c | 22 ++++++++++++++++------
1 file changed, 16 insertions(+), 6 deletions(-)
Thanks!
Reviewed-by: Heiko Schocher <h...@denx.de>
bye,
Heiko
--
DENX Software Engineering GmbH, Managing Director: Erika Unter
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-52 Fax: +49-8142-66989-80 Email: h...@denx.de
