Remove unused piece of code under CONFIG_I2C_REPEATED_START which does
not have any Kconfig entry at all.
Signed-off-by: Aniket Limaye <a-lim...@ti.com>
---
drivers/i2c/omap24xx_i2c.c | 10 +---------
1 file changed, 1 insertion(+), 9 deletions(-)
diff --git a/drivers/i2c/omap24xx_i2c.c b/drivers/i2c/omap24xx_i2c.c
index ebe472e20cd..1fd5f5cc224 100644
--- a/drivers/i2c/omap24xx_i2c.c
+++ b/drivers/i2c/omap24xx_i2c.c
@@ -538,9 +538,7 @@ pr_exit:
/*
* i2c_read: Function now uses a single I2C read transaction with bulk transfer
* of the requested number of bytes (note that the 'i2c md' command
- * limits this to 16 bytes anyway). If CONFIG_I2C_REPEATED_START is
- * defined in the board config header, this transaction shall be with
- * Repeated Start (Sr) between the address and data phases; otherwise
+ * limits this to 16 bytes anyway).
* Stop-Start (P-S) shall be used (some I2C chips do require a P-S).
* The address (reg offset) may be 0, 1 or 2 bytes long.
* Function now reads correctly from chips that return more than one
@@ -608,16 +606,10 @@ static int __omap24_i2c_read(void __iomem *i2c_base, int
ip_rev, int waitdelay,
if (alen) {
/* Must write reg offset first */
-#ifdef CONFIG_I2C_REPEATED_START
- /* No stop bit, use Repeated Start (Sr) */
- omap_i2c_write_reg(i2c_base, ip_rev, I2C_CON_EN | I2C_CON_MST |
- I2C_CON_STT | I2C_CON_TRX, OMAP_I2C_CON_REG);
-#else
/* Stop - Start (P-S) */
omap_i2c_write_reg(i2c_base, ip_rev, I2C_CON_EN | I2C_CON_MST |
I2C_CON_STT | I2C_CON_STP | I2C_CON_TRX,
OMAP_I2C_CON_REG);
-#endif
/* Send register offset */
while (1) {
status = wait_for_event(i2c_base, ip_rev, waitdelay);
--
2.48.1
